(9) Notices when handling Diesel Fuel
Do not mix gasoline, alcohol or blended fuels to diesel fuel. These mixtures are explosive in fuel
tank.
Never remove the fuel cap or refuel with the engine running or hot.
Do not smoke while refueling the tractor or when standing near fuel. Keep any type of flame away.
Maintain control of the fuel filler nozzle when filling the fuel tank.
Do not fill the fuel tank to capacity. Fill only to the bottom of the filler neck to allow room for
expansion.
Wipe up spilled fuel immediately and always tighten the fuel tank cap securely.
If the original fuel tank cap is lost, replace it with an approved one.
Never use fuel for cleaning purposes.
Never use fuel for cleaning purposes.
Arrange fuel purchases so that summer grade fuels are not held over and used in the winter.
Warning
▶
Your tractor is equipped with an Operator Protective Structure (OPS), such as ;
Safety frame (Roll Over Protective Structure (ROPS)) or Falling object Protective
Structure (FOPS) or Cabin with ROPS (Roll Bar).
▶
This structure is a special safety structure for agricultural tractor that used for the
protection of the operator to minimize the possibility of serious injury.
This
structure does not guarantee full protection against all working conditions, i.e.
falling objects, low hanging wires and branches in the forest, orchard or
construction area, etc. NEVER enter or operate these hazardous area without
certified Operator Protective Structure installed.
▶
The Protective Structure and interconnecting components are a certified system.
Any damage, Fire, corrosion or modification will weaken the structure and reduce
your protection. If this occurs, the Protective Structure MUST be replaced with a
new one. Contact your authorized dealer for Protective Structure inspection and
(10) Operator Protective Structure (OPS)
1
1
1
1
- 11
replacement.
▶
In case of an accident, fire, tip or roll over, the following MUST be performed by a
qualified technician before operating the tractor again.
- The Protective Structure MUST be replaced.
- The mounting or suspension for the Protective Structure , operator seat and
suspension, seat belt and mounting components and wiring within the operator’s
protective system MUST be carefully inspected for damage.
- All damaged parts MUST be replaced.
▶
DO NOT attach any device to the Protective Structure for pulling purposes.
▶
DO NOT weld, drill holes, attempt to straighten or repair the protective
structure. The modification can reduce the structural integrity of the
structure which can cause death or serious injury in the event of fire, tip, roll
over, collision or accident and void the warranty.
