5 - 20
(2) Changing Transmission oil
z
Park tractor on level surface and apply parking
brake.
Run engine for several minutes to warm oil and
lower implements and stop the engine.
z
Set container under the drain plug and remove
drain plug
under the transmission and drain oil completely.
z
Clean iron chip stuck to the drain plug and tighten
drain plug again.
z
Add new oil until the oil level is between “Min”
and “Max” of the oil gauge.
z
For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.
5-8. Every 500 hour check
(1) Changing Front axle oil
z
Remove left/right drain plug and drain oil
completely.
z
Assemble the plug again.
z
Add new oil into the oil filling port with checking
the oil level.
z
After 5~10 minutes later, check the oil level again
and tighten the oil gauge.
z
For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system.
Clean around oil filling port, and then pull the oil gauge.
Caution
Drain plugs
(both side)
Drainage plug
“Max”
“Min”
<Oil gauge>
Oil filling port
& Oil gauge
TM oil gauge
