5 - 14
(4) Checking Front axle oil
z
Turn the oil gauge counter-clockwise and pull it
up.
z
Check If the oil level in the gauge scale is in
between the maximum and minimum mark.
z
If necessary, add new oil into the oil filling port.
(after 5~10 minutes later, check the oil level
again)
z
For oil specification, refer to “Lubricants and
Capacity” at end of this chapter.
(
See page 5-4
)
(5) Battery check
z
Refer to “Batter handling and Notices”
(See page 5-26)
(6) Air cleaner (Dry type)
z
(See page 5-9)
Oil gauge
(7) Hydraulic hoses and Leakage
z
Stop the engine and place all the transmission gears in neutral and lower down the implement to the
ground.
z
Periodically check hydraulic system for leaks or damaged parts - kinked, crushed, flattened, hard
blistered, heat cracked, charred, twisted, soft or loose covered hoses and fittings.
z
Before removing hydraulic components, make sure to check that hydraulic pressure is relieved
completely. The leaks of pressurized oil can cause a fatal physical injury. For further information,
refer to the section, “3-3. Hydraulic system” in this manual.
