SAFETY PRECAUTIONS
Important :
Indicates important information when using the equipment. It may damage to the
equipment if not followed.
Note : Indicates helpful information when using the equipment.
WARNING :
Indicates a potentially hazardous situation that, if not avoided, could result in
DEATH or very serious INJURY.
CAUTION :
Indicates a potentially hazardous situation that, if not avoided, may result in minor
or moderate INJURY.
Understand that your safety and the safety of other persons is measured by how you service and operate this
backhoe. Know the position and operations of all controls before you begin operation. Make sure you check
all controls in all safe area before starting.
The safety information given in this manual does not replace any safety codes, insurance needs, federal, state
and local laws. Make sure your machine has the correct equipment required by your local laws and
regulations.
Read this manual completely and thoroughly.
Make sure you understand all controls. All equipment has a limit. Make sure you are aware of the
stability and load characteristics of this backhoe before you begin operation.
This safety alert symbol indicates important safety messages in this manual. When you see this
symbol, carefully read the message that follows and be alert to the possibility of personal injury
or death.
SAFETY PRECAUTIONS
DANGER :
Indicates an imminently hazardous situation that, if not avoided, will result in
DEATH or serious INJURY.
A frequent cause of personal injury or death is
persons falling off and being run over. Do not permit
others to ride on your tractor. Only one person, the
operator, should be on the machine when it is in
operation.
Before leaving the tractor, stop the engine, put all
controls in neutral, engage the parking brake and
remove the key from the ignition.
When using remote hydraulic tractor valves on some
tractors, the backhoe lift and dump cylinders will
continue
moving
unless
the
control
levers
are
manually returned to neutral, or until relief pressure is
reached at the ends of piston strokes. Observe the
bucket movement and maintain control with the
control levers.
Stop the backhoe arms gradually when lowering or
lifting loads.
Stay off of slopes too steep for safe operation. Shift
down before you start up or down a hill with a heavy
load. Avoid "free wheeling"
Before starting the engine of your tractor, make sure
all operating controls are in park lock or neutral
position.
Operate controls only when seated in the operator's
seat.
Equip your tractor with a ROPS cab or frame for your
protection. See your tractor operator's manual for
correct seat belt usage.
- 6 -
Summary of Contents for I3030
