5-9. Every 600 hour check
(1) Changing Front axle oil
Stop tractor on a level surface and apply parking
brake.
Remove left/right drain plug and oil gauge to
drain oil completely.
Wrap the sealing tape on the plug and tighten the
drain plug.
Add new oil into the oil filling inlet.
Check if the oil level is between low and high
marks after about 5 minute later.
Drain plug
Oil filling inlet & Oil gauge
(2) Changing Transmission oil
Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm oil
and lower implements and stop the engine.
Set container under the drain plug and remove
drain plug under the transmission and drain oil
completely.
Clean metal powder stuck to the drain plug and
tighten drain plug again with cooper washer.
Add new oil until the oil level is between low and
high marks of the oil gauge.
Oil capacity : 30 L (7.9 U.S.gals.)
Tighten the oil gauge.
Oil capacity : 5.5 L (1.5 U.S.gals.)
<Oil gauge >
High
Low
Oil filling inlet,
Oil gauge
5
5
5
5
- 22
Oil capacity : 30 L (7.9 U.S.gals.)
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
