Station ID
Station ID is often confused with System ID. This function is used where more than one station of the same es-
tablishment may be paging staff pagers. The indicators on the pager will show this code. To set a different sta-
tion number:
1. Press SETUP.
2. Press F1 (MORE) until you are asked for the authorization code.
3. Now type 5-6-7-8-9.
4. Press F1 (MORE) until the display shows 1: Prgm Station ID.
5. Press 1 (1: Prgm Station ID.)
6. The display shows the current station ID number (default is 1).
7. Press a number to use (0 – 9) to change the default ID number.
8. Press F1 (OK) to confirm or F2 (Exit) to return without change.
Adjust Transmit Power
The range may be increased or decreased from the transmitter by adjusting the transmit power level. The
power levels are 1 through 5. Find a power level using Range Test(See Following) that best suits your restau-
rant and leave it that way.
Default from the factory is power level 3. Reset only by direction from LRS
To set the power level:
1. Press SETUP.
2. Press F1 (MORE) until you are asked for the authorization code.
3. Type 5-6-7-8-9.
4. Press MORE (F1) until the display shows 2: Program TX Pwr.
5. Press 2 (2:Program TX Pwr).
6. Set the required power level (from 1 through 5).
7. Press Enter.
8. Press F1 (OK) to confirm or F2 (Exit) to return without change.
Range Test
This allows you to see where you can and cannot be paged. Although the range may vary slightly during
busy times, this allows you to get a rough idea of where guests can roam.
Caution: To begin Range Test
(DO NOT PERFORM A RANGE TEST WHEN GUESTS HAVE
PAGERS BECAUSE THEY WILL ALL FLASH AT ONCE)
1. Press SETUP.
2. Press MORE (F1) until asked for an authorization code.
3. Enter 5-6-7-8-9.
4. Press F1 (MORE) until the display shows 2: Run Range Test.
5. Press 2 (2: Run Range Test).
6. Take 2 or 3 charged pagers and walk around the site. The pagers will flash about once every 5-10
seconds.
7. The point where the pager does not flash consistently is the maximum range. If range is required
beyond this point, an alternate antenna or repeater may be used.
8. Press F4 (EXIT) to stop range test.
Long Range Systems
19
T7400A User Manual
