Lowrance HDS Live, Installation Manual

Page: 40 / 70

Transducer type
Ú
Note:
The transducer type is automatically set for transducers
that support Transducer ID (XID) and is not user selectable.
Transducer type is used for selecting the transducer model
connected to the sonar module. The transducer selected will
determine what frequencies the user can select during sonar
operation. In some transducers with built-in temperature sensors,
the temperature reading may be inaccurate or not available at all if
the wrong transducer is selected. Transducer temperature sensors
are one of two impedances - 5k or 10k. Where both options are
given for the same model transducer, refer to paperwork supplied
with transducer to determine impedance.
Autopilot settings
For the trolling motor autopilot, no special setup is required. See the
operator manual for further details.
The NAC-1 autopilot computer (outboard motor autopilot) requires
setup as described in the following sections.
Ú
Note:
The word rudder is sometimes used in menus and
dialogs. In this context, the outboard motor acts as a rudder.
Autopilot data sources
Provides automatic and manual data source selection for the
outboard autopilot.
Commissioning
Used to calibrate your boat’s steering (cable steer or hydraulic
steering) with the NAC-1.
Ú
Note:
The autopilot must be commissioned prior to first use
and any time after autopilot default settings have been
restored.
Cablesteer rudder calibration
1.
Select
Commissioning
.
2.
Select
Rudder feedback calibration
.
3.
Follow the onscreen instructions.
40
Software setup | HDS Live Installation Manual