Lowrance ELITE Ti2, Installation Manual

Page: 32 / 56

A
B
• To show the depth from the lowest point of the vessel to the
bottom, set the offset equal to the vertical distance between the
transducer and the lowest part of the vessel,
A
(negative value).
• To show the depth from the water surface to the bottom, set the
offset equal to the vertical distance between the transducer and
the water surface,
B
(positive value)
• For depth below transducer, set the offset to 0.
Water temperature calibration
Temperature calibration is used to adjust the water temperature
value from the sonar transducer. It may be required to correct for
localized influences to the measured temperature.
Calibration range: -9.9° - +9.9°. Default is 0°.
Ú
Note:
Water temperature calibration only appears if the
transducer is temperature capable.
Transducer type
Ú
Note:
The transducer type is automatically set for transducers
that support Transducer ID (XID) and is not user selectable.
Transducer type is used for selecting the transducer model
connected to the sonar module. The transducer selected will
determine what frequencies the user can select during sonar
operation. In some transducers with built-in temperature sensors,
the temperature reading may be inaccurate or not available at all if
the wrong transducer is selected. Transducer temperature sensors
are one of two impedances - 5k or 10k. Where both options are
32
Software setup | ELITE Ti² Installation Manual