Operation
39
EN
3. Wait until the start screen disappears.
– If the sensors were connected to the device for less
than 2 hours during a recording, recording time is
not adequate for reliable results. A message
appears in the display to indicate that the recording
time was insufficient (
Analysis time insufficient
).
– If the sensors were connected to the device for
more than 2 hours during a recording, you can
read off the results in the results display after the
end of the recording (see “5.6 Read out results” on
page 40).
5.5 After the recording
1. Check whether the serial number of the device
matches the serial number on the form on the reverse
of the patient’s instructions for use.
2. Check whether the patient’s name on the form on
the reverse of the patient’s instructions for use
matches the name of your patient.
3. Press the button on the device.
4. Wait until the start screen disappears and the results
display appears.
The results display shows the results of the last
recording.
5. Call up the individual pages of the results display by
pressing the button on the device.
6. Read off the results (see “5.6 Read out results” on
page 40).
7. Enter the results on the form on the reverse of the
patient's instructions for use.
8. Call up the
Erase data
page by briefly pressing the
button on the device, possibly several times.
Erase data
and
Next calibration
appear in the
display.
