Lowenstein Medical prisma VENT30, Assembly And Main Instructions For Use And Maintenance

Page: 29 / 64

LM
T 6
84
31
0
9/2
02
1
EN
|
29
5 Settings in the menus
5.2.3 Patient menu - Ventilation
The Ventilation menu shows the settings for current ventilation parameters. The
parameters displayed vary depending on the ventilation mode set. This menu can only
be manipulated in the expert menu. The settings cannot be changed in Patient mode.
If more than one preconfigured program is enabled in the device, the program can be
selected here.
Patient circuits
Here you can see which patient circuit is being used and
perform the tube test.
The O
2
supply must be switched off during the tube test.
For the accuracy of therapy, it is helpful to conduct this
test when changing circuit. This process checks for
resistance, compliance and leaks.
Humidifier stage
You can change the humidifier stage of the humidifier
here. The setting suitable for you depends on room
temperature and humidity. In the event of dry airways,
increase the humidifier stage. If there is condensation in
the circuit, reduce humidifier stage.
Autostart
You can switch Autostart on or off here.
If Autostart is switched on, the device switches on when
a breath is taken into the patient/ventilator interface.
Filter timer You can reset the filter change reminder function here.
Date/time You can set current time and date here.
Device status
The following information can be found here:
• Device name
• Serial number
• Firmware version
• Information about the battery (if present)
• PIC*
• Transferred up to*
• ID code*
*Available only if a modem is connected.