Lowe 1200 Classic, Operator'S Manual

Page: 9 / 16

7
7
(also see Checklist in Machine Setup Section)
WARNING: Diesel fuel or hydraulic fl uid under pressure can penetrate the skin or damage eyes. Fluid
leaks under pressure may not be visible. Never use a bare hand to fi nd leaks and always wear safety
goggles for eye protection. Such fl uid, if injected into the skin, must be removed within a few hours by a
doctor familiar with this type of injury. Make certain power source is disconnected before servicing.
Shut off power, relieve pressure, and disconnect power source before performing maintenance.
VII
TROUBLESHOOTING
Symptom Possible Cause Action
Jerky Cold oil or air in lines
Loader hydraulic pump or system Give time to warm up.
See loader’s manual.
Slow Restriction in lines, couplers,
or in loader’s hydraulic system
Worn, damaged, or insuffi cient
loader hydraulic pump
Loader oil fi lter Check with pressure and fl ow gauge.
See loader dealer. Request fl ow (GPM)
and pressure (PSI) check.
Check for dirt and grime. See if fi lter is
installed correctly.
Insuffi cient digging
capacity Hydraulic pump in loader or motor in auger
Excessive load See your dealer. Request pressure check.
Reduce digging load because
load exceeds capacity of system.
Wrong direction Hoses not properly connected Re-install properly.
Oil leaks Hydraulic motor seals are worn or damaged
Loose fi ttings on hoses or motor
Hoses are loose or damaged See dealer for replacement of seals.
Tighten or replace as required.
Tighten or replace as required.
VIII
MAINTENANCE
Maintenance Required Length of Operation Type of Maintenance
Gear Box Lubricant 50 hours initially,
then once each year
Drain and replace gear oil. Use EP 80-90 wt. gear oil. Use 21 oz. in the BP-150, BP-210,
BP-230. Use 16 oz. in the TJ-100. Use 27 oz. in the A-275. Use 54 oz. in the A-400.
Motor Drive Chain 50 hours or as needed Lubricate. Chain should have about 1 inch (25.4 mm) of free play.
Auger Teeth As needed for wear Replace. Pay particular attention to outside teeth
Auger Center Point As needed for wear Replace.
Auger Attaching Pin As needed Check for bends, cracks, breaks, and visible wear. Replace if any of these
conditions are present.
Auger Driveshaft Before each use Check for bends, cracks, breaks, and visible wear. Replace if any of these
conditions are present.
Unit Mounting Pins (2) Before each use Check for bends, cracks, breaks, and visible wear. Replace if any of these
conditions are present.
NOTE: Use of a gear puller is highly recommended when removing a sprocket from a shaft.
Chain Lubricant can be any premium grade grease or commercial chain lube (motorcycle chain lubricant works
very well). The lubricant will do its best job when applied to a warm chain. Give the lubricant time to soak into the
working parts of the chain before resuming operation.
*Always follow manufacturer instructions*
*AAA Rent-All 225-291-1356*