10
8.0 EASY FAST INTERFACE SOFTWARE
8.1 MINIMUM REQUIREMENTS OF THE COMPUTER TO INSTALL THE SOFTWARE
Operating system -
Windows 98 2nd edition or following versions
Memory (RAM)
-
At least 16 MB
Hard disk
-
At least free 20 MB upon installation
Screen resolution
-
800 x 600 or higher
Moreover, it is necessary to have installed Internet Explorer 5.5 or later versions.
8.2 SOFTWARE INSTALLATION
To install the calibration software insert the CD-Rom in the reader of the computer and wait until the
guided installation window appears.
Should the installation program not start, select “Start” from the “Application Bar”. Select “Execute” and
enter: “D:\setup.exe” (where “D” indicates the CD-Rom reader).
During the installation you will be asked to select the folder in which the program shall be installed. We
suggest not changing the pre-set folder.
After the installation, the program icon is created automatically on the desktop.
8.3 INTRODUCTION
The calibration software works by hardware key code 7155002 and can be opened without being ne-
cessarily connected to the control unit.
To connect to the control unit, it is instead necessary that the PC and the control unit are correctly
connected by a serial cable (Code 0570001 Installation kit) and a serial USB adapter, if the PC is not
equipped with a Serial port (Code 4685001 Serial USB adapter). Alternatively you can use the SERIAL
KIT WIRELESS cod. 1685001.
Moreover, the control unit has to be connected to the +12 volt battery (RED - BLACK wire), to the
ground (BROWN wire) and to 12V under key (dashboard ON - engine OFF).
8.4 MAIN MENU
From this menu, it is possible to access all sub-menus of the calibration software that are given and
individually described here below.
On the lower part of the page there is the following information:
3
1
6
2
5
3
1)
This indicates if the control unit is connected or not to the calibration software. It is important to
remember that all settings and regulations being performed with the disconnected control unit will
be lost upon connection, unless they are previously stored in a confi guration fi le.
When the program is opened, it automatically tries to connect to the control unit.
