Doc: I437GB04_16.docx 09/03/2016
p. 10 / 37
Parameter settings (setup) from front panel
To access the parameter programming menu (setup):
o
Set the board to
OFF
mode
o
On the normal measurement display, press
▲
and
▼
at the same time to recall the
main menu
o
Select the icon
. If it is not enabled (greyed out) it means that the password must be entered to unlock it (see
Password protected access
).
o
Press
to access the setup menu.
The figure shows the setup sub-menus in which all the parameters are grouped according to their function.
Press
▲
or
▼
to select the required menu and press
to confirm.
Press
OFF
to exit and go back to the measurements display.
Set-up: menu selection
The available sub-menus are shown in the following table:
Code
MENU
DESCRIPTION
M01
UTILITIES
Language, brightness, display pages etc.
M02
GENERAL
Characteristic system data
M03
PASSWORD
Access code setup
M04
BATTERY Battery
parameters
M05
ACOUSTIC ALARMS
Control of internal buzzer and external siren
M06
SOURCE LINES (SRCx)
Characteristic source data
M07
BREAKERS (BRKn)
Characteristic breaker data
M08
SWITCH
Load transfer mode
M09
SOURCE LINE CONTROL (SLCx)
Source line acceptability limits n.
M10
COMMUNICATIONS
Communication parameters ()
M11
AUTOMATIC TEST
Period, time, automatic test mode
M12
DIGITAL INPUTS
Programmable digital input functions
M13
DIGITAL OUTPUTS
Programmable digital output functions
M14
MISCELLANEOUS
Functions, such as maintenance etc.
M15
LIMIT THRESHOLDS
Programmable limit thresholds
M16
COUNTERS Programmable generic counters
M17
TIMERS
Programmable timers for PLC logic
M18
REMOTE ALARMS
Alarm remoting on RGKRR module
M19
ANALOG INPUTS
Voltage/current/temperature inputs
M20
ANALOG OUTPUTS
Voltage/current outputs
M21
USER ALARMS
Programmable alarms
M22
ALARMS TABLE
Alarm enabling and effect
Select the sub-menu and press
to view the parameters.
All parameters are shown with code, description, current value.
Set-up: parameter selection
