2
BLUETOOTH VINTAGE RADIO
Contents of the carton
1x vintage radio
1x USB charger lead
1x 3.5mm AUX lead
1x manual
Charging the Bluetooth Speaker
Plug the mini-USB connector of the USB charging lead into the 5V DC socket on the rear panel of the radio and the
other end into a suitable USB port or a mains adaptor.
IMPORTANT NOTE : Appliances containing Lithium-ion batteries
1.
PRIOR
to using the unit for the first time, please charge
fully
the battery
2. Charge the battery regularly after each use.
Don't wait until it is discharged
!
3.
DON'T
allow the battery to discharge completely, otherwise it will lose 20% of its capacity or even be
totally
damaged!
If the voltage becomes too low, the internal circuits are not powered anymore and it will become
impossible to recharge the battery!
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40% of its capacity and
check/charge it once per month.
The life time of the battery depends on the observance of these recommendations.
**
BATTERIES ARE NOT COVERED BY THE WARRANTY
**
We cannot be held responsible for damaged batteries further to the non-observance of these basic rules.
Location of controls
1.
Volume control
2.
Bluetooth mode : Short press for Bluetooth mode, long press for AUX mode
3.
FM mode
4.
Frequency scale illumination
5.
FM frequency adjustment
6.
ON/OFF switch
7.
Antenna
8.
USB charging port
9.
LED indicator
10.
AUX IN jack
FM Function
Prior to using the unit for the first time, please fully charge the built-in battery. Push the ON/OFF switch
⑥ to the
ON position. The unit will be set to radio mode. Press button
④
to light up the frequency dial. Rotate the frequency
adjustment knob ⑤
to search a radio station. Control the volume via the dial
①.
If the radio reception is not clear,
move the unit near to a window or a balcony to get a stronger signal. Adjust the position of the antenna.
Pairing the speaker with a Bluetooth enabled device
To use Bluetooth function, shortly press the BT key
②.
A tone is heard and the Bluetooth LED indicator will flash
green. Set your mobile phone or other Bluetooth enabled device to search for Bluetooth devices. When the
Bluetooth device finds the radio, select “MADISON
”
in the list of found devices. After successful pairing, a tone will
be heard and the Bluetooth LED indicator will slowly flash green.
(If a previously paired device is within the range when the speaker is turned ON, the speaker will connect to it
automatically).
Using as a Wired Speaker
To use the speaker as a wired device, plug one end of the 3.5 auxiliary lead into the AUX jack on the back panel of the
unit and the other end into your device or computer’s headphone jack. Use the volume control
①
to set the desired
volume.
GB
