16
Changing/Resetting Password
Changing the log on password can only be performed in
Setup Mode and
when
the receiver is Online. Changing the password requires that the old
password be entered, followed by the new one. The receiver automatically
places a slash [/] between the two passwords as they are entered. The
password must consist of six numbers.
Change the password via:
Setup > 3)Change Password
Resetting the log on password can only be done in
Setup Mode and when
the receiver is Offline. This feature is not normally used, except to provide
a recovery mechanism if the current password has been lost or forgotten.
Should this occur, contact Lotek support staff, provide the receiver serial
number and a six-digit number a password will be provided to enable
access to the Reset Password function to log on to the receiver as follows:
Reset the password via:
Setup > 3)Reset Password
MANUAL MODE
Manual
mode refers to those receiver states in which the user must fully
specify and dynamically modify receiver parameters, e.g, frequency, gain,
in real time, and optimize operation based on local ambient conditions to
improve detection probability. Any changes to these settings are
performed using the keypad.
During operation in Manual mode, data are not automatically logged by
the receiver
.
. Detected signals are displayed on the LCD screen and are
audibly discernible from the speaker. Adjust the volume as required using
the OFF/VOL knob.
After pressing the
Manual
key on the keypad, four menu items are
presented:
