7
You can connect this system either using the supplied RCA or coaxial cables.
8
INSTALLATION OF RECEIVER
CONNECTION OF RECEIVER TO TELVISION USING COAXIAL CABLE
1. Place the wireless receiver near your television (or monitor)
2. Connect the supplied 9V 500 mA DC adapter to the DC IN jack at the back of
the receiver and plug it into an electrical outlet.
Ensure the Power Switch on the Receiver and Camera are turned OFF prior to
Proceeding with the following steps.
NOTE
1.Connect one end of the coaxial cable to the back of the receiver. Plug the other end
of the coaxial cable to the television.
2.Turn the Camera and Receiver ON. Set your TV to Video mode to view the
receiving signal from the Camera. (Consult your televisions owners manual on
setting the television to Video (Aux) mode.
3. Search the channel 1-4 by using Channel Selector Switch on the Receiver and
Camera. Select best one for optimum reception in your area.
4. Adjust the antenna direction as necessary.
Both Camera and Receiver units must be set to same channel.
NOTE
ELECTRICAL OUTLET
RECEIVER BACK
TELEVISION
1. Attach the stand base to the wall or ceiling where you want to
install the camera. Locate a wall stud or ceiling joist and secure bracket using the
three supplied screws.
2. Attach the camera to the stand and firmly tighten the swivel..
3. Attach the camera with the stand to the stand base and firmly tighten the joint knob
on the stand base.
4. Connect the supplied 12V 500mA DC adapter to the DC IN jack at the rear of the
camera and plug it into the electrical outlet.
Your wireless camera has both AC or battery option. When using the AC option with
rechargeable batteries, your camera will automatically switch to back up battery feature
during a power outage providing you with uninterrupted power to the camera. The
battery option also provides you the flexibility to move the camera from room to room.
WIRELESS CAMERA - AC OPTION ONLY
1. Ensure the power switch on the camera is turned OFF.
2. Connect one end of the power supply to the DC IN jack located at the back of the
camera. Plug the other end into an electrical outlet
WIRELESS CAMERA - USING RECHARGEABLE BATTERIES
1. Insert 8 rechargeable ‘AA’ batteries (not included) into the camera battery
compartment. WARNING: TO PREVENT INJURY AND/OR DAMAGE TO THE
UNIT, ENSURE THE BATTERIES ARE ALIGNED PROPERLY AND BATTERY
TYPES ARE NOT MIXED.
2. Ensure the slide switch labeled Recharge/Alkaline is set to the ‘Rechargeable’ setting.
3. Carefully slide the battery compartment into the camera
4. Ensure the power switch on the camera is turned OFF.
5. Connect one end of the power supply to the DC IN Jack located at the back of the
camera. Plug the other end into an electrical outlet.
WIRELESS CAMERA - USING ALKALINE BATTERIES
1. Insert 8 alkaline ‘AA’ batteries (not included) into the camera battery compartment.
WARNING: TO PREVENT INJURY AND /OR DAMAGE TO THE UNIT, ENSURE
THE BATTERIES ARE ALIGNED PROPERLY AND BATTERY TYPES ARE NOT
MIXED
2. Ensure the slide switch labeled Rechargeable/Alkaline is set to the ‘Alkaline’
setting.
3. Carefully slide the battery compartment into the camera
4. Ensure the power switch on the camera is turned OFF.
5. Connect one end of the power supply to the DC IN Jack located at the back of the
camera. Plug the other end into an electrical outlet
WIRELESS CAMERA – INSTALLATION
