1. Connect one end of the RCA cables to the Audio/Video jacks at the back of the
Receiver. Plug the other end of RCA cables into the Audio/Video in jacks on your
VCR.
2. Connect one end of another RCA cables to the Audio/Video jacks on your television
Plug the other end of RCA cables into the Audio/Video Out jacks on your VCR.
3. Turn both the Camera and Receiver ‘ON’. Set your TV to Video mode to view the
signal from the Camera. (Consult your televisions owners manual on setting the
television to Video (Aux) mode.
4. Search the channel 1-4 by using Channel Selector Switch on the Receiver and
Camera. Select best one for optimum reception in your area.
5. Adjust the antenna direction as necessary.
NOTE
Ensure the Power Switch on the Receiver and Camera are turned OFF
before proceeding following steps.
NOTE
Both Camera and Receiver units must be set to same channel.
NOTE
INSTALLATION OF RECEIVER
CONNECTION OF RECEIVER TO A VCR
10
VCR REAR
TV REAR
RCA CABLE
(NOT
SUPPLIED)
RCA CABLE
(SUPPLIED)
ELECTRICAL OUTLET
VCR
RECEIVER
5
CONTROLS AND FUNCTIONS
CAMERA
1. LENS
B&W or color (depending on system
purchased)
2. MICROPHONE
Built-in condenser microphone provides
audio capability from camera to monitor
television
3. 6 INFRA RED LED’s
- Enhances
picture quality in low light conditions.
(Available in B&W system only)
4. 2.4 GHz ANTENNA
High gain directional dipole antenna
sends Audio and Video signals to the
monitor.
5. BATTERY COMPARTMENT
Provides 4-5 hours of power
to camera. Requires 8 rechargeable
NiCd/NiMh batteries, or 8 1.5V alkaline
batteries
6. STAND MOUNTING SOCKET
Reinforcement lock for camera stand.
7. CHANNEL SELECTOR SWITCH
Slide switch for the channel 1-4 selection.
8. ON/OFF POWER SWITCH
Controls power to the camera. Note:
Please ensure you set the switch to the
OFF position before plugging the
AC adapter into the unit.
9. DC IN JACK
Plug the 12V(500mA) AC Adapter in here.
FRONT VIEW
1
2
3
5
7
4
6
8
9
SIDE VIEW
BATTERY COMPARTMENT
