System Setup Controls
33
ENG
RS-485 SUBMENU
The information in the RS-485 submenu allows
users to configure the settings for an RS-485
Device.
NOTE:
The configuration settings for this
section would be provided with the
documentation included with the RS-485
device.
•
BAUDRATE:
Set the Data
Transmission (Baud rate) to1200,
1800, 2400, 4800, 9600, 14400,
19200, 36400, 57600 or 115200 bps.
•
DATA BIT:
Set the Data Transmission
Bit to 7 or 8.
•
PARITY BIT:
Set the Data
Transmission Error Check Bit to odd,
even or none.
•
STOP BIT:
Set the Data Transmission
Stop Bit to 1 or 2.
PAN/TILT DEVICE SUBMENU
The information in the PAN/TILT Device
submenu allows users to configure the settings
for a PTZ Camera.
PAN/TILT DEVICE SUBMENU
NOTE:
The configuration settings for this
section would be provided with the
documentation included with the PTZ Camera.
•
CHANNEL:
Select the Channel where
PTZ camera is connected.
•
ID:
Assign the specific ID of the PTZ
camera.
•
MODEL:
Select the model of PTZ
camera.
•
PAN/TILT TEST:
Test PTZ Camera.
F/W UPGRADE
The DVR supports upgrading the Firmware
through a USB Memory Stick.
If a USB Memory Stick is not detected by the
system, a failure message will appear:
If a USB Memory Stick is detected with valid
Firmware files, the following screen will appear:
Press the PLAY Button to update the firmware,
or press the STOP Button to cancel.
