35
User Manual
6. Frequently Asked Questions
6.1
How can I disconnect the cables from the FISH PRO HD
+
in case I need to do so for the installation?
♦
Open the FISH PRO HD
+
box unscrewing the four screws (see the
following figure).
Fig. 6.1 - The FISH PRO HD
+
♦
Once the screws are removed, pull out the panel and the Printed
Circuit Board (PCB). Unscrew the cables from the PCB.
♦
Wire the cables as needed.
♦
Reconnect the cables to the PCB (see the Fig. 4.5 for reference).
♦
Push the panel towards the case (be sure to have well positioned
the rubber gasket). Close the FISH PRO HD
+
box screwing the four
screws.
6.2
How can I set optimal operating parameters.
Optimal operating parameters can be set accordingly with the intended use of
the Fish Finder, anyway to quickly get optimal operational parameters for
fishing it is possible to select the FISH preset from the Fish Finder Setup
menu, while for cruising it is possible to select the CRUISE preset.
6.3
What are preset modes?
Preset modes are pre-defined settings of the Fish Finder operating param-
eters. You can use them to quickly set the Fish Finder in the most commonly
used operating modes. These are:
♦
CRUISE: sets the Fish Finder in full auto mode with the sensitivity
settings (GAIN OFFSET, NOISE level and STC) optimized for dis-
playing at best the bottom.
♦
FISH: sets the Fish Finder in full auto mode with the sensitivity set-
ting optimized for target searching.
6.4
How can I restore the Fish Finder default operating
parameters?
Simply select the CRUISE or the FISH preset. This will restore optimal oper-
ating parameters for either cruising or fishing.
