8
G-Link-200-OEM
USER MANUAL
3.2 Gateway Communication
Drivers for the USB gateways are included the SensorConnect software installation. With the
software installed, the USB gateway will be detected automatically whenever the gateway is
plugged in.
1. Power is applied to the gateway through the USB connection. Verify the gateway
status indicator is illuminated, showing the gateway is connected and powered on.
2. Open the SensorConnect™ software.
3. The gateway should appear in the Controller window automatically with a
communication port assignment. If the gateway is not automatically discovered,
verify the port is active on the host computer, and then remove and re-insert the USB
connector.
Figure 4. USB Gateway Communication
3.3 Connect to Nodes
Several methods can be used in SensorConnect to establish communication with the nodes:
the automatic node discovery on the same frequency, automatic node discovery on a different
frequency, and add node manually.
3.3.1 Automatic Node Discovery on Same Frequency
If the base and node are on the same operating frequency, the node will populate below the
Base Station listing when powering on the G-Link-200-OEM.
Figure 5. Node Discovered On Same Frequency
