6
5
VOL
0.25mL
：
Copy
991
：
YZ1515 ID 0.80
YZ1515
YZ2515
Select Tubing ID
：
0.80 1.60 2.40
Ext Control
：
ON
OFF
Pump Address
：
1
Menu Diagram
Running Inter face
1.System Setting
2.Control Mode
3.Disp Setting
4.Calibration
1. Pump head Tube
&
YZ1515 ID 0.80
2.Ext Cont.
ON
：
3.Address
1
：
4.Footswitch
G
：
5.Back T.
1 2
： . "
Flowrate
Dispensing
Disp Vol 2.02mL
:
Copy No.
10
：
Flow 2.043mL/min
:
Pause T.
1.0
：
"
Flowrate
Dispensing
1.System Setting
2.Control Mode
3.Disp Setting
4.Calibration
1.System Setting
2.Control Mode
1. Pump head Tube
&
1.System Setting
2.Control Mode
2.Ext Cont.
ON
：
3.Address
1
：
1.System Setting
2.Control Mode
2.Ext Cont.
ON
：
3.Address
1
：
Pump Head Installation
The pump head is mounted on drive before the pump leaves the factory. Follow
below procedure for changing another pump head.
Loose the two M4 screws which connect the pump head and the drive.
Dismantle the pump head slightly.
Inser t the flat end of the pump head's shaft to the slot of drive's coupling.
Make the location hole of the pump head match the location pin of the drive.
Inser t the two mounting screws into the mounting holes of the pump head.
Then tighten the mounting screws to connecting hole of drive. (For more
information, please refer to pump head's operation manual)
Turn off the power before changing the pump head.
Note:
System Setting:
All the setting can not be done when pump is running.
Pump head and tubing setting
Press the
to enter
inter face, press
again to enter
submenu of
, then press
again the pump will show all
the suitable pump head, turn
to select needed pump head, press the
again to confirm the selection of pump head and the pump will show all the
suitable tubing, turn
to select needed tubing and press
to confirm or
press
to return to previous menu.
Knob
System Setting
Knob
Pump Head & Tube
Knob
Knob
Knob
Knob
Knob
Exit Key
External Control
Set the pump to enable the
or not.
On: Enable
Off: Disable
Set the
Press and turn
to highlight the external control line. Press
to enter
next inter face, turn
to select
or
then press
to confirm or press
to cancel the selection and return to previous menu.
In external control mode, the status of external control can be changed when the
pump stops.
External Control
External Control
External Control
External Control
Knob
Knob
Knob
On
Off
Knob
Exit Key
Press and turn
Knob
Press and turn
Knob
Address:
When control computer controls many pumps through RS485 inter face, it must
identify each pump's I. D. This pump I.D. should be unique. It's the identification
of this pump. Maximum 30 pieces BT100-1F can be controlled through RS485 at
the same time.
Setting
of each pump
Press and turn the
to highlight the
line. Press
again to enter
next inter face, turn Knob to select
, and then press
to confirm or
press Exit Key to cancel the selection and return to previous menu.
Address
Knob
Address
Knob
Pump ID
Knob
1 .
2 .
3 .
BT100-1F OPERATING MANUAL
BT100-1F OPERATING MANUAL