7
8
Flowrate
Dispensing
Disp Vol 2.02mL
:
Copy No.
10
：
Disp Vol
：
2.02 mL
Copy No.
：
10
4.Footswitch G
：
5.Back T.
1 2
： . "
Footswitch
：
Gated
Trigger
Back Time
：
"
1.2
1.System Setting
2.Control Mode
1.System Setting
2.Control Mode
4.Footswitch G
：
5.Back T.
1 2
： . "
1.System Setting
2.Control Mode
1.System Setting
2.Control Mode
3.Disp Setting
4.Calibration
1.System Setting
2.Control Mode
3.Disp Setting
4.Calibration
Disp Vol 2.02mL
:
Copy No.
10
：
Footswitch Setting
Footswitch has two kinds of working status.
Press footswitch, the pump star ts running; Press footswitch again,
the pump stops.
The pump runs as long as the footswitch is pressed.
Set Footswitch
Press and turn
to highlight the Footswitch line. Press
to enter next
inter face. Turn
to select
or
, then press
to confirm or
press
to cancel the selection and return to previous menu.
The pump identifies the Longer Footswitch automatically. When the pump
connects the footswitch, the
Key on operating panel is invalid no
matter the remote control is on or off.
Trigger:
Gated:
Knob
Knob
Trigger
Gated
Knob
Exit Key
Note:
Start/Stop
Knob
Press and turn
Knob
Press and turn
Knob
Back Suction Time Setting
In dispensing and filling state, to prevent the liquids from dropping to cause
error when the filling stops, the pump will back-turn a suction angle to suck
back the liquids. The back suction is the same for each filling operations, it
doesn't influence the filling accuracy.
Set
:
Press and turn
to highlight the back suction time line. Press the
to
enter next inter face, turn
to adjust
, press
to
confirm or press
to cancel the adjustment and return to previous
menu.
Back Suction Time
Knob
Knob
Knob
Back Suction Time
Knob
Exit Key
Control Mode
The pump has two kinds of working mode:
and
.
Set
Press and turn the
to highlight control mode line. Press
to enter next
inter face, turn Knob to select control mode, press
to confirm or press
to cancel the selection and return to previous menu.
Flowrate
Dispensing
Control Mode:
knob
Knob
Knob
Exit
Key
Dispensing Setting
Before dispensing process, the parameters including Pump Head, Tubing,
Dispensing Volume, Copy number, Flow Rate and Pause time must be set.
Dispensing Volume: the volume that the pump dispenses between every time
interval.
Press and turn
to highlight dispense setting line. Press
to highlight
dispensing volume line. Press
again to highlight the value of the volume.
Turn
to select Dispensing Volume. Press
to confirm or press
to cancel the selection and return to previous menu.
Knob
Knob
Knob
Knob
Knob
Exit Key
Copy No.: the total filling number. Its range is
0 to 9999.
Press
to highlight copy number line. Press Knob to enter next inter face
Turn
to select copy number. Press
to confirm or press
to
cancel the selection and return to previous menu.
If the
is “0”, the dispensing process of the pump will continue until
press
key or turn off the pump to stop dispense process.
form
Knob
.
Knob
Knob
Exit Key
Copy No.
Start/Stop
BT100-1F OPERATING MANUAL
BT100-1F OPERATING MANUAL