London Electronics IL2-P, Manual

Page: 21 / 36

21
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Lockout Switch must be OFF
Press 3 seconds
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press OK. You can now specify the
lowest input signal. Use DIGIT to
select each digit in turn, and the UP
or DOWN arrow to increase or
decrease each digit’s value, as
required. eg set
04.0000 if your
input is 4-20mA
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press to accept
1
2
3
4
5
Press to accept
Set1
Set2 Output
Alarms
Digit
OK
Max/Min Reset
Display now shows
rd Lo
briefly. You
can now specify the low reading.
Use DIGIT to select each digit in turn,
and the UP or DOWN arrow to increase
or decrease each digit’s value, as re-
quired. eg set
000.000 if your display
range is 0 to 100.000
Theoretical Calibration - Low end calibration
This is when you type in the sensor’s theoretical signal level at the top and bottom of
its range and the value to display, for each signal level.
If you have not done so before, please select Theoretical Calibration mode
from the
Meter Calibration page.
Done!
You can set Zero first, if you prefer, but you will not be able to change the decimal
point position in the ZERO calibration step. This will not be an issue if your zero
calibration reading is 0, but may become confusing otherwise.
This feature is available in Easy and Advanced Modes
OFF
Circuit board ON
Display shows
theor
followed by
dC A
or
dC V
, depending
on whether you have chosen current or
voltage input, then
In Lo