10
Q:
Film does not develop normally under very low temperature (<5 °C).
A:
Use your hand to keep the film warm after it has been ejected,
be aware not to put pressure on or bend the film.
Q:
Bright dots appear in the photo and they occur in the same
position in different photos.
A:
Open the Back Door
[9]
of your LomoGraflok and check the
roller located near the Film Ejection Slot
[7]
to make sure it
is clean and free of dust and dirt. Gently clean the roller if
required.
Q:
The photo framing is different from how it appears on the
ground glass.
A:
Check if the Film Plane Calibration & Mask Attachment
[13]
is correctly installed, make sure the correct side is facing the
ground glass.
Q:
Film is jammed while ejecting.
A:
Make sure your LomoGraflok is detached from the camera
while ejecting film and Film Ejection Slot
[7]
is not blocked.
Summary of Contents for LomoGraflok 4x5 Instant Back
