Lombardini LDW 502, Service Manual

Page: 81 / 98

- 81 -
service manual
mod. 051135
7
H
G
P
N
L
M
7 - Clean the cover (H) witha a jet of air.
8 - Check the state of the filter cartridge (G).
If necessary, remove the cartridge, knock
it repeatedly against a flat surface to
eliminate dirt and clean with a jet of air.
9 - Return the cleaned filter cartridge or
replace it with an original spare.
Caution - Warning
Do not use liquids to clean the filter
cartridge.
10 - Replace the cover (H) and re-hook it
carefully into place.
Filtro “a cartuccia”
1 - Check that the contact surfaces are
perfectly clean and intact.
2 - Eliminate any blockages in the ducts.
3 - Slip on a new gasket (L).
4 - Bring the manifold (M) up to the cylinder
h e a d a n d h o o k o n t h e m i n i m u m -
maximum device.
5 - Install the manifold (M) without tightening
the screws (N) completely.
6 - Tighten the screws in an alternating
pattern to a final torque of 25Nm.
7 - Check the state of the filter cartridge. If
necessary, remove the cartridge and
clean with a jet of air.
8 - Return the cleaned filter cartridge or
replace it with an original spare.
Caution - Warning
Do not use liquids to clean the filter cartridge.
9 - Replace the filter housing.
10 - Mount the cover (P).
minimum-maximum
device
governor spring
INSTALLATION OF ASSEMBLIES