39
THIS MANUAL IS PROPRIETY OF
ECOWIND by LOMBARDINI
- ALL FORMS OF REPRODUCTION, PARTIAL OR OTHERWISE, IS STRICTLY PROHIBITED
G
B
+ 24
FS
2c
Fc
min 200 A - 12 V
3c
A1
Pa
La
P
+ 12
min 100 A - 24 V
A2
Fig. 68
Fig. 67
Fig. 66
Fig. 65
Fig. 64 a
N
N
A2
3 -
ASSEMBLY AND INSTALLATION
Red Cable
Black Cable
BATTERY
Step Description
6
Connect the cable bundle
Fc
from the Power Unit to the extension
P
supplied by inserting FRAMATOME connectors
2c
, in the connectors
3c
(fig. 65-66).
7
Connect the Power Unit’s power cables
La
to the supplied power cable extension
Pa
by joining the two connectors
A1
and
A2
. See fig. 65-66.
NB:
After this operation is complete, it is RECOMMENDED that the two connectors
A1
and
A2
be secured with a nylon
clamp
CN
, as shown in figure 69.
8
After completing all connections, connect the red cable of the extension (
Pa
), complete with electrical power fuse
FS
(fig. 68), to the positive pole of the vehicle’s original batteries (fig. 67).
9
Next attach the other eyelet of the black cable
Pa
of the extension to the negative pole
of the battery (fig. 67).
WARNING: The black cable must be connected to the battery!!! And not to the frame!!!
10
WARNING
Make sure the supply red cable is firmly attached
( Pa )
, avoiding points that are mobile or subject to rubbing,
and not allowing it to hang, to prevent tearing or contact with the vehicle frame which might cause damage to
the electrical/electronic circuit in the system or the vehicle’s battery.
Step Description
5
WARNING
Before to connecting the power connectors
A1
and
A2
, use the protective for electrical contact
“NYOGEL “
N
see fig. 64a. Supplied inside the kit.
Open the tube of gel protection “NYOGEL”
N
and
insert it in the pin female of the connector
A2
like
showed on fig. 64a, operation needed against the
oxidation and corrosion of power metallic pin.
Summary of Contents for ECOWIND 350 C AUS
Page 2: ......
