8
2: INSTALLING COVER
(Continued)
Pivot link attached
to anchor
E. With anchor post toward cover, test
placement on top of cab in flat area between
ribs. Ensure pivot link is flat against anchor
post, then mark location. Repeat for opposite
side.
IMPORTANT: Ensure minimum 1” space
between cover and closest point on cab.
NOTE:
Improper placement of anchors will
require ordering replacements.
Flat area on
top of cab
Ensure minimum
1” space
Anchor post
Ensure pivot link flat
against anchor post
F. Release pivot link from anchor and secure in
clip on each side.
G. Clean marked locations with alcohol pad.
H. Shake primer, squeeze at black dot to start
liquid flow, then prime locations and allow to dry.
NOTE:
Primer typically dries in 5 minutes at
room temperature.
Clean
marked
locations
!
CAUTION: Strong magnetic pull may
cause improper placement.
I. Peel adhesive liner from anchors and
adhere to marked locations. Apply pressure
for 10 seconds, then close cover.
NOTE:
After installation, cover should
remain in closed position for at least 48
hours. During this time period, anchors bond
to cab and cover typically conforms to truck
box.
Anchor
!
CAUTION: Air and surface temperatures
must be above 60°
F for proper adhesion.
D. Swing pivot links out from clips and attach
anchors.
