The welding machine can be configured to communicate exclusively with wireless foot pedal or remote
control panel. This is done by a simple process of synchronising the wireless remote control and the
machine frequencies. Each interface frequency assigned is unique, so it is possible to use several
wireless control systems/machines in the same area with no problems. The direct range of the machine
and the remote control.
Synchronization of the remote control with the welding machine
，
follow these instructions:
1) Ensure the welding power supply is switched off.
2) Press and hold the parameter select/adjust knob on the front panel of the power supply
(2-4 seconds) while at the same time turning the machine ON using the ON-OFF switch on the
back of the welding power supply.
3) When the display on the front panel of the power supply is blank, release the control knob. Turn on
the remote control or foot pedal while at the same time pressing any buttons on the remote
control panel or foot pedal, the digital meter on the front panel of the welding power supply flick
twice to indicate the synchronization is successful and complete.( Synchronization has to
accomplish in 10s after the display is blank.)
4) Switch the machine off and back on again to start welding operation.
5) If the operation is unsuccessful, repeat steps 1 to 4.
6) During operation, the front panel control on the power supply is still functional but the remote
control panel or foot pedal has higher priority level.
7) When the remote control panel or foot pedal is idles for 10 seconds, it will automatically go into
“sleep” mode.
8) Only front Panel Control is active when wireless remote control or foot pedal is in “sleep” mode.
Any operation on the wireless remote control panel or foot pedal will “wake it up and resumes
control of the machine.
How to remove the control function of Remote control box on welding machine
1) Ensure the welding power supply is switched off.
2) Press the encoder on the front control panel of the power supply, meanwhile turn on the machine.
3) Pressing the encoder about 10 seconds, until the control panel display "rSt", then it sucuceed.
On-off switch
3.5
Remote
control
Configuration
3.5.1
Wireless
remote
control
Configuration
