Logitech 904286-0403 - Marble Mouse Trackball, User Manual

Page: 4 / 80

2
Installing the Batteries
2.
Installing the Batteries
1. Remove the cover on
TrackMan Live! by using
your thumbs to pull the cover
toward the narrow end of
the unit.
2. Place the flat ends (negative
pole) of the AAA batteries
against the spring(s).
A diagram
in the battery compartment shows
the correct battery installation.
3. When the batteries are
installed, carefully slide (or snap) the cover back into place.
4. Slide the Range switch from Off to Lo or Hi . (The Lo setting extends battery life.)
If the battery light near the battery compartment remains lit for a few seconds,
the batteries are good. If the light flashes, or there is no light, change the batteries.
Use the
Lo setting for distances of up to 2 meters and the Hi setting for distances
up to 10 meters.
3.
Battery Warning
When replacing the batteries, use only AAA alkaline batteries. Do not mix batteries
of different types. Discard all used batteries according to the battery manufacturer’s
instructions. Exercise care when handling batteries. When batteries are misused,
they may explode or leak, causing burns and personal injury. Do not open a battery
or mutilate, dispose of in a fire, expose to heat above 100
o C, immerse in water,
install improperly, or recharge. Conducting materials, such as rings, bracelets, and keys,
can short out a battery causing it to overheat and possibly leak or explode.
When TrackMan Live! is not used for long periods of time, remove the batteries and store
them in a dry place at normal room temperature.
Recess
Cover Range
switch
Channel
light
Battery light
Channel
button
Spring
(not in view)