Installation Guide
Connecting the LAN
Connect the CAT6 Ethernet cable with the RJ45 plug to the LPoE LAN connector
of the camera. Shielded Ethernet cables are required. The connector can be
found at the back of the camera. Power supply of the camera can be provided
over the Ethernet cable if it is connected to the LPoE router of the LOGIPIX
NVR.
Connecting the Power
When LPoE feature cannot be utilized, a 12V DC external power supply is
necessary for the camera. Connect the power cable with the ferrules to GND
and Phase (+12VIN) pins of the camera. The spring connectors can be found at
the back of the camera. Use a screwdriver to push in the black colored plastic
spring lifter, connect the wires then release the spring lifter!
Connecting the I/O ports
4 programmable Input/Output ports (NO, NC / OC 0.5A/30V) are optionally
available in the camera. Connect the external I/O devices to the appropriate
pins! The spring connectors can be found at the back of the camera. Use a
screwdriver to push in the black colored plastic spring lifter, connect the wire
then release the spring lifter!
I/O ports can be configured for the following functions (only a few examples):
- Trigger the IR reflector
- Alarm output
- Alarm input
- General logging
- Setup change
Having the appropriate license an audio input (MIC) and an audio output (SPK)
is available in the LOGIPIX camera. The spring connectors can be found at the
back of the camera.
12/18
