Installation Guide
4. Place the markers at every image border!
5. The placed markers can be relocated. Move the mouse pointer over the
marker, press
Shift
then the middle mouse button at the desired
position! The undesired markers can be deleted by
Shift+right mouse
button
.
6. After you have finished the placing of the markers, press
F2
, and the
program is going to stitch the camera pictures!
White balance
1. If the gradient between the images is not smooth enough, you have to
set an area on both images, covered by some special points. In these
areas, the difference in white balance between the cameras can be
corrected.
2. Press
F2
then the key
V
to enter the white balance editor mode of the
panorama picture!
3.
Three different areas can be designated close to the image border. One
area is at the top of the image, another is in the middle and the last can
designate the bottom. Hold the
Shift
button and designate the areas at
the border of an image by placing at least 3 points by the left mouse
button. Place the points on the neighboring image as well to appoint
approximately the same area. You can go back to edit stitching points if
you press the
N
key. If you've finished with editing, press
F2
again!
80/80
