Logic LBMULB12, Instruction & Installation Manual

Page: 6 / 24

6
First Time Use of the Oven
Unpack the oven. Remove any insert cards or plastic bags. Use a damp cloth to carefully wipe the interior and
exterior of the oven. Clean all the detachable parts in hot, soapy water before using.
Heat the oven on maximum for 45mins (ensure the clock has been set). There may be a little smoke and odour
upon initial start up (for about 15mins). This is normal. It is due to the protective substance on the heating
elements which protects them from the effects of corrosion during shipping from the factory.
Using the Controls
The oven can be warmed up using the bottom and top
heaters, as well as the grill. Operation of the oven is
controlled by the oven Function Control knob and the
temperature regulator Thermostat Control knob as well.
• This is a 24-hour clock. When the oven is connected to the mains power for the first time or when
the power is resumed after a power interruption, the LED display will show “0:00”. To re-set the
clock, simply follow the first 3 steps above.
• When the symbol “A” and the three “0” will flash on the screen, the oven cannot be operated by
using the Function Control knob and the Thermostat Control knob.
• When the icon is displayed on the screen, the oven can be operated manually.
Mode
Function Control
To use the Function Control and Temperature Control,
press the knob to pop out. Turn the knobs to the selected
function / temperature (printed on the side of the knob(s)),
then push in the knob to confirm. The oven can be switched
off by turning the setting to the off position “0”. (The oven
can also be operated with the knobs left out.)
Mode
Thermostat Control
Clock Setting
The time must be adjusted before starting to use the oven.
1. The symbol “A” and the three “0” will flash on the screen. Press the + and –
buttons at the same time until the icon will display on the screen and
the icon will flash on the screen.
2. Press the + / – buttons to set the time.
3. After the adjustment, the icon will stop flashing.
4. If the display is not flashing, adjust the time by pressing the + and - buttons at the same time. The icon will
start to flash. Follow Steps (2) and (3) above to set the time.
* All images are for indication only; please refer to your individual unit for actual item.
LBMULB_X12_IB_120601_Annie.indd 6 12年6月1日 上午11:59