10
SYSTEM SETUP
1
Install the LS6100 units as described in HARDWARE INSTALLATION section.
2
Setup optional parameters on LS6100 if necessary (for example, RS232 baud rate and
beeper pitch).
3
Setup the LS6100 station address used for quick identification of the station.
4
Setup LS6100 IP address, subnet mask and port number to the required values. Check
with system administrator for proper settings. Note that the IP address must match the
IP group of the host server and the TCP port address must match the port number used
by the application software.
5.
Save parameters and exit setup.
6
Verify that the values on the boot up screen shows the correct set up values. If not,
repeat step 2 to 5 to correct the settings.
7
The setup for one LS6100 is now completed. Repeat as necessary for each LS6100 in
the system, ensuring a unique IP address for each LS6100. Always verify the setting on
the boot up screen.
8.
Check the host server IP address to make sure
that it’s in the same IP group as the
LS6100 units. Setup the server IP address if necessary.
9.
Setup the application software if necessary, including TCP port number setting.
10. Run the application software or a test program to verify functions of the system.