11
OPERATING INSTRUCTIONS
TIME & CALENDAR
When the unit receives a RCC (radio-controlled clock) signal, a sync-time symbol
will appear on the
LCD, and the unit will synchronize daily. Flashing wave segments on the sync-time symbol means RCC
signals are being received. Every day the unit will automatically search for the time signal at
2:00 a.m., 8:00 a.m., 2:00 p.m., and 8:00 p.m. Make sure to place the unit away from sources like TV
sets and computers to prevent interference.
Manually Setting the Time
The display console is designed to synchronize itself using the RCC signal, however you can set the time
manually if needed. During initial setup, you will need to press and hold the RCC button for eight (8)
seconds to deactivate the RCC reception. Press and hold the RCC button again for eight (8) seconds to
turn the signal back on.
1.
To manually set clock, press and hold the CLOCK button for two (2) seconds after deactivating the
RCC reception and the 12/24 hr. symbol will begin to flash.
2.
Press the UP or DOWN button to adjust the time zone.
3. Press the CLOCK button again to proceed to the next setting.
4. Settings will cycle through the following options: Time Zone > Hour > Minute > Second > Year >
Month > Day > Hour offset > Weekday language > DST AUTO/OFF.
5.
Press the CLOCK button one final time after adjusting all settings options to save and exit, or the
console will automatically save and exit the menu after 60 seconds of no button presses.
NOTES: DST (daylight saving time) feature is only valid when the RCC function is on.
The DST feature is set to AUTO by default.
During RCC signal reception, the display backlight would automatically be set to a dim level.
Setting the Alarm Time
If you’d like to use your display console as an alarm clock, follow these instructions to set the alarm time:
1.
In normal operating mode, press and hold the ALARM button for two (2) seconds until the alarm
hour starts flashing. This indicates that you have entered the alarm time setting mode.
2. Press the UP or DOWN button to adjust the alarm hour. Press and hold either button to move
through the hours quickly.
