Sound & Electronics LOG GmbH | Sankt-Georgen-Gasse 7, 8020 Graz, Austria | [email protected] | www.logaudio.com
3
MONOLOG square
User Manual
Volume adjustment with remote control
The volume of the MONOLOG square can be adjusted with the supplied infrared remote
control.
Adjust the volume
If you want to change the volume, press the “
Vol. up +
“ or “
Vol. down –
“ key. If you hold
down one of these buttons, the volume changes continuously.
Note:
Be sure to point the remote at the MONOLOG square as soon as you press a key.
Mute
If you press the “
Mute
“ button you can mute the MONOLOG square or deactivate the mute function.
Note:
Be sure to point the remote at the MONOLOG square as soon as you press a key.
Pairing the remote control
At factory settings, the remote control is not paired with the MONOLOG square. If you have several remote
controls of the same type, pairing is useful to avoid conflicts.
1. Use a pen or a straightened paper clip to press the pairing button on the back of the MONOLOG square
2. The device is now in pairing mode for
30 seconds
3. Now press any key on the desired remote control (e.g. the “
Mute
“-key)
4. The device is now paired with this remote control and accepts only commands from this remote control
Note
: If the MONOLOG square does not receive any command from a remote control during the 30 seconds it is in pairing
mode, the pairing is canceled and the MONOLOG square accepts commands from any remote control of the same type.
Wake-up function
In case of inactivity, the MONOLOG square automatically activates the standby mode after a while to avoid unnecessary
power consumption. The automatic wake-up functionality automatically reactivates the MONOLOG square when there
is an incoming audio signal via Bluetooth, AirPlay® or DLNA. Accordingly, the loudspeakers can remain permanently
connected to the power connection without affecting the energy consumption or the lifetime of the product.
Vol. up +
Vol. down –
Mute
