17
Grain Bag Unloader OM
Switch to Working Position (Cont’d)
STORAGE POSITION
2
3
TRANSPORT POSITION
1
Remove the cylinder stop (1) from the axle and place in
the storage position (2) and secure with the retaining pin
(3) and clip .
Be sure the PTO driveline, hydraulic connectors and the
electrical connector are installed . See “Installing Grain
Bag Unloader to the Tractor” on page 14 .
Remove the right cross auger guards/extensions and the
left extension brace from the stored position .
1
6
5
3
4
2
Install the cross auger extension (1) onto the center auger
shaft (2) . Install the extension auger cage (3) to the main
unit (4) using four bolts (5) and nuts (6) . Do not tighten at
this time, do the next step first .
1
1
Align the holes of the auger extension with the holes of
the center auger shaft . Secure with two bolts (1), nuts
and washers . Tighten the nuts and bolts installed in the
previous step . See “Torque Specifications” on page
95 .
(Procedure continued on following page.)
Set-up Instructions
Summary of Contents for GrainLogix XLB10
