LOFTNESS GrainLogix XLB10, Owner'S Manual And Parts Book

Page: 20 / 104

14 Grain Bag Unloader OM
Installing Grain Bag Unloader to the
Tractor
1
2
Remove the PTO driveline from the stored position .
Remove the retaining pin (1) and lower the PTO driveline .
Install the chain (2) .
1
Retract sleeve (1), slide the PTO driveline onto the
tractor PTO shaft until the sleeve slides forward and
locks driveline to shaft . Push and pull the PTO driveline
back and forth several times and make sure it is securely
attached to the PTO shaft .
NOTE: The PTO driveline is telescopic to fit most
lengths. Minimum distance between crosses
is 37.8 inches (96 cm) and maximum distance
between crosses is 53.5 inches (136 cm) If
the distance is more or less than that, refer to
the PTO driveline manufacturer’s literature for
procedures for adjusting the length. It may also
be possible to move the draw bar location on the
tractor.
(Procedure continued on following page.)
Connecting the Grain Bag Unloader
(Cont’d)
1
3
2
4
Back the tractor up to the hitch of the unloader .
Insert pin (1) (1-1/8 in . to 1-1/4 in . pin) and secure with
retaining clip (2) .
Install the safety chain around the tractor drawbar (3) and
fasten the chain ends together (4) .
Connecting to Truck
1
3
4
2
Back the truck up to the hitch of the unloader .
Insert pin (1) (1-1/8 in . to 1-1/4 in . pin) and secure with
retaining clip (2) .
Install the safety chain around the truck’s hitch frame (3)
and fasten the chain ends together (4) .
Set-up Instructions