![background image](http://html1.mh-extra.com/html/loftness/battle-ax-50-series/battle-ax-50-series_owners-manual-and-parts-book_1934323028.webp)
22
Battle Ax OM
Skid Removal/Replacement
WARNING:
Shut down and lock out power
from the excavator before removing skids.
Lift the Battle Ax off of the ground about 6 inches. Place
blocks under the rotor (not under teeth) to support the
shredder when lowered. DO NOT place blocks under the
skids.
1 2
2
1
3
1 2
2
1
3
Hook End Skid Shoe
Belt End Skid Shoe
For belt end skid shoe, first remove the belt cover. Refer
to “Removing Belt Cover and Access Covers” on page
18 for instructions.
For hook end skid shoe, first remove the hook. Refer to
“Removing Hook” on page 19 for instructions.
Remove nuts (1) and slide carriage bolts (2) out. Lower
the skid (3) and remove.
To install new or repaired skid shoe, align holes in skid
shoe with holes on frame. Re-install the bolts, add the
nuts and tighten securely.
Cutter Bar Adjustment and
Replacement
31
33
2
14x
WARNING:
Shut down and disconnect
hydraulic hoses from excavator before
adjusting the cutter bar.
Loosen the series of bolts (1) with washers (2) securing
the cutter bar (3) to the frame, 14 places total.
Cutter bar can be flipped or rotated to present a fresh
edge. Replace if needed.
IMPORTANT
: Make sure new or repaired cutter bar is
clean and free of debris before installing.
FAILURE TO DO SO COULD RESULT IN
SEVERE DAMAGE TO THE MACHINE!
Reinstall the washers and bolts and tighten.
Maintenance
Summary of Contents for Battle Ax 50 Series
