18
In case of installation on hollow compartment with doors, you need to place a separation panel
under the hob. Keep a minimum distance of 10 mm between the bottom of the device and the
surface of the panel, which must be easily removable to allow sufficient access for any technical
assistance.
If the hob is going to be installed on the top of an oven, precautions must be taken to guarantee
an installation in accordance with current accident prevention standards. Pay particular attention
to the position of the electric cable and gas pipe: they must not touch any hot parts of the oven.
Moreover, if the hob is going to be installed on the top of a built in oven without forced cooling
ventilation, proper air vents must be installed to guarantee an adequate ventilation, with the
lower air entering with a cross section of at least 200 cm2, and the higher air exiting with a
cross section of at least 60 cm2.
Fastening the top
Every cook-top is equipped with a special washer. For the installation proceed as follows:
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the washer S along the external border.
- Introduce and place the cook-top in the hole made in the piece of furniture, then block it with
the V screws of the fastening hooks G.
N.B. In order to take off the inox hob from the sheet metal box, it is necessary to remove the
screws on the cups (above the hob) and the four screws below as shown in picture.
Attention.
Do not use electric screwdrivers or torque wrenches to fix the top. Hand tighten
without forcing the screws.
Installation room
This appliance is not provided with a device for exhausting the products of combustion.
Therefore, it is necessary to discharge these smokes outside. The room where this appliance is
installed must have a natural air inflow, to ensure a regular gas combustion and room
ventilation: the necessary air volume must not be lower than 20 m3.
