Loewe Connect 22 SL, Operating Instructions Manual

Page: 28 / 120

- 28
english
Setting options for all types of reception:
Select favoured signal source.
Select the signal source from a list, the station of
which is to be at the top of your station list (starting
with station slot 1).
The listed signal sources depend on the selected
antennas and, if the set is equipped with a satellite
tuner, the type of satellite system used and the
received satellites.
OK Proceed .
Accept Logical Channel Number no / yes .
In some countries, digital channels (DVB-T, DVB-C,
DVB-S) are transmitted with a prescribed programme
number per channel; these are known as “Logical
Channel Numbers” – “LCN”.
If you select yes here, these prescribed channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. Depending on the
LCN, spaces or double channel allocations can occur
in the numbering of the channel list.
OK Proceed .
Initial installation
Favoured
signal source
Logical
Channel
Number
OK
OK
INITIAL INSTALLATION
Favoured signal source
DVB-T
DVB-C
ASTRA1 19,2°E
Antenna/cable (analogue)
Proceed Back
Setting options for DVB-S reception (continued):
After you have made the previous settings, you should
receive picture and sound of the selected satellites (only
possible for Astra1 and HOTBIRD).
OK Proceed .
Select and adapt settings.
If several satellites are received, the following settings
must be made for every satellite. The scope of the settings
may differ depending on the selected satellite.
You can state whether coded stations are to be searched
for in the search/update. Select
yes to save all found
scrambled stations. However, these stations can only be
received in connection with a CA module and the appro-
priate Smart Card. Handling of the CA module is described
on page 55.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when
no is preset.
If you want to run the station search independently of
the channel grid, select
frequency search for the search
method.
The symbol rates are specified by the satellite provider
and do not normally need to be changed.
OK Proceed .
Test reception
Settings
Encrypted
stations
Search
method
Symbol rates
OK
INITIAL INSTALLATION
The ratio of signal (Carrier) to noise (Noise) (C/N) shows you the quality of the
received DVB signal. The greater the value the better.
Astra1 19,2°E C/N Level
The signal level tells you how strong the DVB reception is.
Proceed Back
OK
yes
INITIAL INSTALLATION (ASTRA1 19,2°E)
Scrambled stations no
Search method Channel search
Symbol rate 1 (DVB-S) 27500
Symbol rate 2 (DVB-S) 22000
Proceed Back
OK
OK
no yes
INITIAL INSTALLATION
Logical Channel Number
Accept Logical Channel Number
Proceed Back
OK