Loewe 3D Orchestra 3.1 IS, Operating Instructions Manual

Page: 20 / 116

3D Orchestra
Instruction manual
English
20
Connecting the speakers to the power supply
Insert the small plug (S) of the supplied power cord into the power
receptacle on the bottom side of the speaker. Feed the power cable
through the strain relief (Z) intended to prevent inadvertent disconnec-
tion of the power cord.
Insert the large plug of the power cord into a 220-240V 50/60 Hz
power outlet.
Proceed in the same way with additional speakers.
Insert the small plug (S) of the supplied power cord into the mains
socket at the side of the subwoofer.
Insert the large plug of the power cord into a 220-240V 50/60 Hz
power outlet.
Switch on the subwoofer by switching the POWER toggle switch to
position I .
S Z
Line In
Bass
Intensity
Subw
+12dB -12 dB
RF Reset
0
I
S
„
Connecting the speakers
LED display on the 3D Orchestra Speaker
LED display on the 3D Orchestra Speaker
In the 3D Orchestra Speaker, a white LED (L) is installed that provides
information on the operating status.
Normally, all 3D Orchestra Speakers should always display the same
operating condition. Differing displays or rapid flashing indicate a
malfunction.
LED Operating mode
Lights brightly On - the 3D Orchestra Speaker is ready for
operation
Lights dimly Off - the 3D Orchestra Speaker is in its energy-
saving stand-by mode
Flashes slowly The 3D Orchestra Speaker starts
Flashes quickly There is a malfunction (e.g. radio interference)
L