3 - Setup instructions - Nihon Kohden 1550K
3 - Setup instructions - Nihon Kohden 1550K
3.1 - Cable
3.1 - Cable
selection
selection
Switch off the ergometer and
the system.
You will need the RS-232 cable
(part no. 930730) to establish communication between the Lode ergometer and your system. The lay-
out of the cable is as shown in the picture.
Connect the RS232 cable to the
System. . Note that the
connector marked for ECG
system
side is connected to the SIO 1
port.
If an internal blood pressure
device will be used, you only
need a trigger cable under
exceptional conditions.
• In case the used ergometer is
an Excalibur sport with blood
pressure
• Or when on special request of a customer a external triggered blood pressure unit instead
of standard blood pressure unit has been built in.
• In these to cases you will need a trigger cable (part no. 930709). The lay-out of this cable
is as shown in the picture.
4/22
INTERFACE SHEET - NIHON KOHDEN 1550K - CPET ERGOMETER / VERSION: 1.0 - 2016-01-15
