Lode ERGOMETERS, Service Manual

Page: 49 / 51

Service manual Valiant treadmill V1.00 49
6.5 Walking belt alignment
The alignment of the walking belt is correct when the belt runs in the middle of the supporting
plate. The walking belt alignment can be adjusted by means of the socket screw located at the
left side of foot at the end from the frame.
Set for a speed of approx. 10 km/h; the walking belt will react faster to adjustments made at a
high speed. To adjust the walking belt alignment, use the left socket screw. To make the belt
move to the left side, turn the socket screw anti-clockwise. When the walking belt moves too
much towards to the left side, turn the same socket screw clockwise (see figure). Make sure to
use only the left socket screw to adjust the walking belt tension, using both socket screws
could result in a high walking belt tension. This will shorten the service life of the walking
belt and it will make the drive motor run unnecessary heavy.
The figure above shows the Valiant from the rear side.