Lode ERGOMETERS, Service Manual

Page: 29 / 51

Service manual Valiant treadmill V1.00 29
3.4 Replacement instruction belt & deck
Required tools
• Allen key #3,#4,#5,#6
•
Slotted screw driver #2
• Philips screw driver #2
•
Ring spanner #10
Instruction
1. Use the slotted screwdriver to remove the cable from the controller to the Motor
compartment of the Valiant (figure 1)
2. Remove the #3 Allen screws at the back side of the white housing (figure 2)
3. Remove the pin plug out of the left and right side of the white housing (figure 3)
4. Now remove the white housing, be careful with the earth potential plug (figure 4)
5. In case side rails are mounted on the Valiant it is wise to remove them first you can
use Allen key #4 for this (figure 5)
6. Remove the Allen screws #6, on left and right side of the roller, that hold the back
roller of the treadmill (figure 6 & 7)
7. Use a Philips screwdriver #2 to remove the two Philips screws in the cosmetic strip
(figure 8)
8. Slide out the strip (figure 9)
9. Slide out the roller (figure 10)
10. Remove the cosmetic covers of the Philips screws that hold the deck in place (figure
11)
11. Now untighten and remove the Philips screws by using Philips screw driver #2 and
ring spanner #10 (see figure 12)
12. Go to the output shaft, which is the front roller of the treadmill. Use Allen key #5 to
remove the two screws left and right that holds the black safety bracket of the this
roller (figure 13)
13. Now untighten the two Allen screws #5 for only one turn counter clock wise. These
are located at the bottom side of the treadmill (figure 14)
14. Now you are able to remove the safety bracket (figure 15)
15. You can access the two aluminium fixation blocks that hold the front roller in position
(figure 16)
16. Remove the belt from the motor to the front roller. (see figure 17 & 18)
17. Slide out the front roller (figure 19 & 20)
18. You are able to lift the deck and remove the belt (figure 21)
19. After you have removed the belt remove the deck as well (figure 22 & 23)
20. Only the chassis of the treadmill will be left (figure 24)
21. Place the new belt and deck in position and reassemble the Valiant treadmill in the
opposite direction as described above.
Important steps are the fixation of the safety bracket of the front roller. The two Allen
screws at the bottom side of the treadmill can easily be forgotten (see figure 14 ).
Make sure you align the belt and adjust the tension of the belt according the specifications
in this service manual.