FUYL Cell™
www.lockncharge.com
STEP 5 - Electrical Reset
In the event that the electrical system is ever overloaded it will automatically switch itself off. The
reset button is located on the “Hidden” socket.
In the event of a serious power flaw the RCD switch in the pedestal may trip. This should be reset. If it
immediately trips again, every power board in every laptop space will need to be checked.
(Note: The side panel has been removed for clarity – it does not need to be removed to reset switch)
STEP 4 - Wiring
Once the FUYL Cell stack has been assembled
and fixed to the floor run the powerleads down
through the FUYL Cells through the rubber
grommets located in the bottom left rear, and the
corresponding grommet in the top left rear of the
FUYL Cell below.
Feed the plugs from the FUYL Cells into the
pedestal and plug them into the RCD protected
4way powerboard.
If no pedestal is being used under the stack, plug the top FUYL Cell into the ‘hidden’ socket inside
the left cover of the FUYL Cell below then plug that FUYL Cell into the ‘hidden’ socket of the bottom
FUYL Cell, then run the lead from the bottom FUYL Cell through the rubber grommet in the side of
the bottom laptop space, through the back of the space and exit out the right hand side grommet
where it can be plugged into an adjacent powerpoint.
Once the powerleads are all connected, switch the power on at the power point and test that power
is supplied to the sockets in every laptop space. The cover panels can now be refitted into the FUYL
Cells.
