FUYL Cell™
www.lockncharge.com
FUYL Cells can be stacked one on top of the other and fixed
to the floor either with or without the optional pedestal. The
maximum number of FUYL Cells in a stack is 3.
UNDER NO CIRCUMSTANCES STACK MORE THAN 3
FUYL Cells
INSTALLING THE FUYL Cell STACK
Identify the desired location for the stack, ideally where a
powerpoint is located low on a wall. The pedestal has an
opening at the lower back to allow access to a wall powerpoint.
If a pedestal is not being used the power lead will exit the
stack on the right hand side. These instructions are for fixing
to a solid concrete floor using the supplied Dynabolts. Other
floor types may be suitable but a qualified structural engineer
should give advice on this.
LocknCharge and the Padlock device are Trademarks of IWS Global Pty Ltd.
Copyright IWS Global Pty Ltd, November 2012.
Disclaimer.
This information is the intellectual property of LocknCharge and may not be distributed, duplicated or
copied in part or full without the written permission. Since the use of this information, the equipment
connected and the conditions by which any LocknCharge product is used is beyond the control of
LocknCharge, it is the obligation of the owner and/or user to determine the correct and safe use of
any equipment and product. To the extent that the law permits, any liability which may be incurred
as a result of the use or future use of a product manufactured or sold by LocknCharge. is limited to
the cost of repairing or replacing the failed product or component at the discretion of LocknCharge
either within, or outside of warranty periods, and does not extend to any loss or damage which may
be caused as a consequence of misuse or failure of the equipment or product or the information
contained herein. LocknCharge. shall not in any event be liable for economic loss of profits, indirect,
special, bodily injuries or consequential damages.
Congratulations on your purchase of the FUYL Cell. Follow these
instructions for easy and fast set-up of your FUYL Cell.
