22
12.6.1
ASSEMBLY
DIAGRAMS
PROCEDURE
1.
Lightly oil the tie bolt threads.
2.
Evenly tighten all bolts. We recommend the use of ratchet / friction spanners.
3.
Ensure clamping is as uniform as possible, thus keeping the frames plates parallel throughout the operation. Avoid
skewing the frame plates by more than 10mm.
4.
Tightening is complete when the distance between the inside faces of the two frame plates is within the compression
length maximum and minimum dimensions as given on the plate pack sequence sheet.
5.
Finally check that all bolts are in tension and clean any spilt oil off the frame plates.
6.
On completion, the unit can be pressure tested at no more than 6 bar g.
Dimension A can be found
within the plate sequencing
sheet.
Summary of Contents for LOKE8-100
