OPERATING INSTRUCTIONS
Court Placement
For best position and widest range of sweep, align the white line
marker on the bottom of the machine with the baseline, placing
the machine at the center mark (as shown to the right).
If desired, move the machine closer to the net to narrow
the sweep or move it back from the baseline to widen it.
To reposition the machine, turn on the horizontal sweep and
turn it off when the machine is in the desired position—It is
not necessary to pick up the machine.
Power the Machine
Turn the machine on using the POWER switch on the control panel.
• Set the FEED anywhere from 2-12 seconds. 12 seconds is the slowest setting.
• Put 3-4 balls in the machine and wait 20 seconds for the machine to start
feeding. Confirm the elevation, speed, and spin are appropriate; adjust if
necessary. Once you have set the machine up properly, turn the machine off;
load the hopper full of balls, and turn on the machine.
• A 20 second delay allows user to reach other side of court before the first throw.
• When hopper is empty, to turn the FEED off by rotating the knob fully
counterclockwise without turning machine off. This will save battery capacity
and allow time to retrieve balls on the court.
INSTRUCTIONS & REMOTE CONTROLS
Triple Oscillation Setup (Available with elite two and elite three only)
Triple oscillation features random shots across the width and depth of the singles court.
• Turn ON the machine.
• Set the speed to 60 mph and feed rate at 8 seconds.
• Turn on the vertical oscillation.
• Watch the elevation indicator and turn the vertical oscillation off at its
lowest point.
• Adjust the elevation until the balls are just going over the net. If any balls
hit the net, adjust the elevation up. If any balls shoot past the baseline,
adjust the elevation down.
• Turn on the vertical oscillation for deep/short shots.
• Turn on the horizontal oscillation for random left/right.
• Maintain the speed at 60 mph for optimum results.
