䠍
ᾀ
Frame
㻌
head
㻌
holder
Removing the slide switch cover with a hexagonal key wrench
(3 mm opposite fl ats) will expose the slide switch as shown below.
Shift accordingly for the rivet size to be used.
Slide switch cover
Rivet loading port
㻖㻌
Always turn off the power supply before operating the slide switch. The settings cannot be
changed unless the power supply is turned off .
Shift the slide switch as shown below, depending on
the type of rivets to be used.
䕻㻌
Change in settings
䕻㻌
Optional parts
When using rivets of a diff erent size, the slide switch needs to be correctly set.
䠍䠒
ᒍᛖᾔ
ᾝ
ᾖ
ᾛᾘ
ᾢ
ᾗ
Pickup plate U (Type3) with M6 screw
䚷
Code No.
䠖
65329
Pickup plate U (Type4)
䚷
with M6 screw
䚷
Code No.
䠖
65336
Pickup plate U (Type5)
䚷
with M6 screw
䚷
Code No.
䠖
65348
ᾁ
Change in frame head diameter
The side switch is set to the specifi ed rivet
diameter in advance by factory default setting.
䠍
ᾃ
㻖㻌
Adjusting the height may need to be verifi ed to the corresponding rivet size. (See page 11)
Replace with the pickup plate appropriate for the size, and re-assemble in the
reverse order.
䐟
Type 3
䚷
(Dia.
䠖
2.4)
䚷
䐠
Type 4
䚷䚷
(Dia.
䠖
3.2)
䐡
Type 5
(Dia.
䠖
4.0)
SW1
SW2
ON OFF
ON OFF
ON OFF
SW1
SW1
SW2
SW2
Remove three countersunk screws with
a Phillips screwdriver.
Refer to page 8, and replace the frame
head holder with the holder appropriate
for the frame head diameter.
㻖㻌
Remove any dirt found on frame head holder
or fi nger holder, before re-attaching them.
(See page 24)
