䠍
ᾀ
䠍
ᾁ
Turn the air valve clockwise to turn on the
air supply.
䠍
ᾂ
Turn on the power switch.
(The indicator LED lights up in green.)
䠍
ᾃ
䠍
ᾄ
ATTENTION:
䞉
If rivets will not feed properly, the rivet feeding unit needs to be aligned. (Refer to page 10)
䞉
If the riveter suction is not functioning, rivets cannot be fed.
䠍
ᾅ
If there is a low volume of rivets remaining, the feeding capacity of the feeder
is decreased. In this case, add rivets.
Indicator LED
Air cock
Load rivets
Rivet
Frame head holder
䐟
䐠
䠍䠏
ᒍᛖᾔ
ᾝ
ᾖ
ᾛᾘ
ᾢ
ᾗ
⅐
⁁⁂‷⁄″⁆※⁀‹‒⁆›‷‒″⁇⁆⁁‒⁄※⁈‷⁆‒‸‷‷‶‷⁄
Press the start button. (Operation is started and the indicator LED turns off once.)
䐟
After the indicator LED lights up in green, insert the riveter into the
inner side of the frame head holder.
㻖㻌
Do not pull the trigger of the riveter at this time.
䐠
After feeding is fi nished, the riveter is pushed back. Then, pull it out.
(A rivet is supplied to the tip of riveter.)
䖂
If no rivet is fed for 6 seconds, the indicator LED fl ashes in red.
㻌䖂
If no rivet is fed for 12 seconds, the indicator LED lights up in
red and the operation is stopped.
䚷㻌㻖
When its operation stops, try the following actions.
䠷
1
䠹
Press activation button then, it's supposed to restart.
䠷
2
䠹
If not restart, refer to page 18.
Load rivets into the rivet loading port.
㻖
Pay close attention to the volume of rivets loaded,
since loading rivets of a volume which exceeds
the specifi ed basket capacity may cause rivets to
back-up. (Refer to page 7)
